Our dedicated team of installers are able to install signs and posts to most substrates. All signage has multiple sizes as is required by RMS compliance.
We can custom make our signs to suit any design and any requirement. Some signs come with anti-graffiti coatings and are cleanable without damaging the sign.
Dirt Bed – Our team will dig the post hole to 300mm deep and 150mm wide. We then clear the soil from the hole and set the pole in position. Once in position, we concrete the pole in while using a spirit level to ensure it is straight.
Concrete – We have two options for concrete:
1. Base Plate – Base plate installation is the more cost-effective option. It is a base that has four pre-drilled holes. We install the baseplate using 4 x anchor screws that penetrate the floor by 70-100mm. The pole is then wedged into the baseplate.
2. Core Drill – Core drilling requires machinery to remove a core from the concrete. The core size will usually be 100mm wide x 300mm deep. This core is then lifted out of the concrete, and we dig out the remaining soil. Once this process is complete, we will place the pole into position, fill the hole with concrete and use spirit levels to ensure the post is straight.
Asphalt – Our team will saw cut the asphalt 200mm x 200mm. Once the asphalt is cut, we jack hammer out the square cut and the top layer of asphalt is removed. We then hand-dig the soil underneath the asphalt to 300mm. We set the pole, concrete it in, and use a spirit level to ensure it is straight.
419/ 14 Lexington Drive Bella Vista, NSW 2153
24 hours 7 days